What is this 200 mah figure?  
View related threads: (in this forum | in all forums)

Tower Hobbies
Enter up to 4 keywords or Tower stock numbers
Logged in as Guest



Users viewing this topic: none
  Printable Version
       

All Forums >> Radios, Batteries, Clubhouse and more >> Batteries & Chargers >> What is this 200 mah figure?
Page: [1]

Login
Message << Older Topic   Newer Topic >>
What is this 200 mah figure? - 7/18/2003 5:39:38 PM   
Zpat



Posts: 558
Joined: 11/9/2002
From: Lima, OH,
Status: offline
The last time I was out flying, I attached my Ace expanded scale volt meter to my batteries and put a 200 mah load on them and it registered a voltage in the red (below 4.8 volts).
I went home and attached the flight pack to a Digi Pace charger and discharged them.
It took over an hour to discharge the batteries. What kind of load is put on the batteries in the discharge mode?
My question is, what is this 200 mah figure we use to check these batteries. Is it the results of 4 servos with tremendous loads imposed on them or what?
If someone could please explain I would be forever grateful.
       Post #: 1

What is this 200 mah figure? - 7/18/2003 7:21:48 PM   
JohnW



Posts: 1495
Joined: 3/22/2002
From: Lincoln, NE, USA
Status: offline
I assume you mean 200ma, not 200 mah. A 200 ma load is just a good load to place on the batteries to assure you are testing the battery under load. It is not excessive. For a 40 sized plane is it probably about equal to the average draw in flight... maybe a bit less, maybe a bit more, depending upon a lot of factors. If a 500mah pack gets you six flights (typical for a 40 sized), each at 10 minutes, then your average draw is actually closer to 500ma (60 minutes to kill a 500mah pack is an average 500ma draw.) I know this isn't exact because higher draw rates are less efficient, but it is close. For comparison, my giants pull close to 4000ma average loads. The 200ma tester load is small by comparison.

If you suspect something is up, double check the battery (cycle it again) and check your tester against a good voltmeter. Also check for a poor connection between the tester and battery. That will give a false low reading.

Cheers.

(in reply to Zpat)
       Post #: 2

What is this 200 mah figure? - 7/18/2003 10:01:40 PM   
JPMacG


 

Posts: 1156
Joined: 1/2/2002
From: Ivyland, PA, USA
Status: offline
Also check the connections to your ESV. Wiggle and twist the connections, connect and disconnect a few times, etc, and see if the reading changes. A little bit of contact resistance can cause a drop of several tenths of a volt.

(in reply to Zpat)
       Post #: 3

Page:   [1]
All Forums >> Radios, Batteries, Clubhouse and more >> Batteries & Chargers >> What is this 200 mah figure?
Page: [1]





Jump to:


Google 



Search | Marketplace | Event Calendar | Local Clubs | Magazine | Product Ratings | New Products | Discussion Forums

Photo Gallery | Member Video Posts | RCU Video Gallery | Instructor Search | Field|Track|Marina Search

Advertisers | Hobby Vendor Resources | Rate Manufacturers | Sign In/Sign Up

SITE MAP!   : :   FORUM RULES

© 2001 - 2007 24-7 RC, LLC, all rights reserved.

Charities we support that also need your help
Yorkie Rescue | Humane Society | ASPCA | Crohn's-Colitis America

Kaango.com Classifieds


0.266RCU1