|
IBEXtrax -> We all have some loose screws.. (7/26/2003 11:49:12 PM)
|
The first time I used my brand new OS 10C slide carb, the slide valve guide screw backed-out and was lost. In that the screw was not initially torqued on assembly, is this a manufacturing defect that would be covered under the warranty?
I have looked and looked for a replacement, But I am stumped as to the screw size. The size is somewhere between 2-56 and 4-40. Is it metric?
Where do I get this slide valve guide screw?
Your suggestions and/or advice is much appreciated,
Warren
|
|
|
|
