Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

  • 1QwkSport2.5r's Avatar
    Yesterday, 05:52 PM
    Thanks Barry! Ill need to to edit the videos some. I only ended up running my Jett .56 and Enya 46-4C to get them broken in. The Jett was a...
    1207 replies | 27226 view(s)
  • 1QwkSport2.5r's Avatar
    Yesterday, 12:26 PM
    Thanks fellas! It's in the mid-40s and my wife took me to lunch. Good time to load up some stuff and go burn some nitro. Richard - it's an...
    1207 replies | 27226 view(s)
  • 1QwkSport2.5r's Avatar
    Yesterday, 10:06 AM
    They Enya 3 plug is the recommended plug for Enya 4-cycles by the Enya factory.
    56 replies | 2994 view(s)
  • 1QwkSport2.5r's Avatar
    Yesterday, 10:05 AM
    It's my birthday and the weather looks decent today... Gonna go burn the cobwebs and ARO out of some engines today.
    1207 replies | 27226 view(s)
  • 1QwkSport2.5r's Avatar
    Yesterday, 05:21 AM
    Os F plugs are not as hot as everyone thinks. For tough engines (especially 4-cycles inverted), try an Enya 3 or better yet a Fox idle bar plug. ...
    56 replies | 2994 view(s)
  • 1QwkSport2.5r's Avatar
    03-26-2015, 03:14 PM
    Well, the motor isn't going to turn a 10x6 at 26,000rpm unless you're running like 12 cells and a ridiculously huge motor and even then you'll likely...
    9 replies | 210 view(s)
  • 1QwkSport2.5r's Avatar
    03-26-2015, 07:20 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    Here in this thread ( http://www.rcuniverse.com/forum/tachometer-readings-173/11221128-enya-60-4c.html ) reply #1, I did a glow plug comparo in my...
    2469 replies | 169832 view(s)
  • 1QwkSport2.5r's Avatar
    03-26-2015, 07:16 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I use Sullivan and Enya remote glow plug clips and the Sullivan clips fit any glow plugs I've used. The Enya clips only fit Enya plugs but they're...
    2469 replies | 169832 view(s)
  • 1QwkSport2.5r's Avatar
    03-26-2015, 05:15 AM
    So what are the dimensions, weight, and CG of the boat in question? Post #1 talks about two boats of two different sizes and one runs good. I'm...
    9 replies | 210 view(s)
  • 1QwkSport2.5r's Avatar
    03-24-2015, 11:47 AM
    Usually higher nitro works better with a more cone shaped combustion chamber where low-mid nitro content works better with a more bowl shaped...
    9 replies | 155 view(s)
  • 1QwkSport2.5r's Avatar
    03-23-2015, 04:26 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I don't know for sure, but I believe the 60 & 80 have different liners (bore is larger for the 80) which would make me think they are not the same...
    2469 replies | 169832 view(s)
  • 1QwkSport2.5r's Avatar
    03-22-2015, 02:13 PM
    1QwkSport2.5r replied to a thread iPhone tach? in Glow Engines
    I guess my only question is this app really worth $9+tax and will it be accurate enough all the time to just leave my Hobbico each at home?
    15 replies | 353 view(s)
  • 1QwkSport2.5r's Avatar
    03-21-2015, 03:13 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    A little status change on my 46-4C Mk I I got recently. I ordered a set of bearings for the whole engine for peace of mind, and before reassembling,...
    2469 replies | 169832 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 11:40 PM
    1QwkSport2.5r replied to a thread iPhone tach? in Glow Engines
    It wasn't noted specifically that was what it was named. It is now. I'll check it out. Thanks.
    15 replies | 353 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 07:06 PM
    1QwkSport2.5r replied to a thread iPhone tach? in Glow Engines
    Curious what app exactly you're talking about. Anyone got an app name I can look up?
    15 replies | 353 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 07:04 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    Should be quite easy if you have the engine in your hand and look through the exhaust port.
    2469 replies | 169832 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 06:58 PM
    I figured it was an early one due to the head sealing setup and it's crankshaft is not bronze bushed. It's been dormant for a long time. It will...
    417 replies | 24471 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 09:46 AM
    Based on what the piston and exhaust port looked like, I doubt this engine had more than a couple short runs on it. There's no pinch but the piston...
    417 replies | 24471 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 09:23 AM
    That could be the case, but even low oil fuel would have left some residue behind. It was bone dry, and even appeared to have saw dust in the...
    417 replies | 24471 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 09:22 AM
    I guess I am a bit surprised they're that good on props. I should get a prop adapter and try it. I have a basketcase 2.5 that I repinched the...
    17 replies | 229 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 09:11 AM
    The pictures below are a glimpse of what it looked like inside when I got it. I thought I'd taken more pictures, but I didnt. I posted these...
    417 replies | 24471 view(s)
  • 1QwkSport2.5r's Avatar
    03-20-2015, 04:29 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    Just search "Enya rebuild parts" and you'll see all of his listings. His name on ebay is "Nubsdoesparts".
    2469 replies | 169832 view(s)
  • 1QwkSport2.5r's Avatar
    03-19-2015, 06:17 PM
    I ran my basketcase .20 Sportster today. I treated it to an abbreviated Sportster break-in of about 35-40min and half a quart of fuel. It ran well...
    417 replies | 24471 view(s)
  • 1QwkSport2.5r's Avatar
    03-17-2015, 09:13 PM
    Yours is coming off the shelf and one of mine is going on the shelf. LoL. My ST S90 is getting yanked off one of my boats and is being replaced...
    1780 replies | 128330 view(s)
  • 1QwkSport2.5r's Avatar
    03-17-2015, 07:48 PM
    That's the way my BSB is setup. Except I'm trashing mine. It's a heavy slug not worth fixing.
    4 replies | 154 view(s)
  • 1QwkSport2.5r's Avatar
    03-17-2015, 07:38 PM
    The only Traxxas .12s I know of were pieces of crap. The Pro .15 was the replacement for the .12 and made more power but still only had a single...
    17 replies | 229 view(s)
  • 1QwkSport2.5r's Avatar
    03-17-2015, 10:34 AM
    I'd probably need to use a prop adapter that moves the prop forward. As it is, the cranks are really short and quite small too so I'm a bit wary of...
    17 replies | 229 view(s)
  • 1QwkSport2.5r's Avatar
    03-17-2015, 05:14 AM
    Looks like a little red dot car engine. I have a Novarossi .21 I thought about putting a prop adapter on and running it aero style..
    17 replies | 229 view(s)
  • 1QwkSport2.5r's Avatar
    03-16-2015, 08:23 PM
    I'll put a 12x6 on one of these little buggers and see what happens. Haha. Heres a few photos of my basketcase .20. It has a spot about 1/4...
    417 replies | 24471 view(s)
  • 1QwkSport2.5r's Avatar
    03-16-2015, 12:13 PM
    I'd seen a post about a guy using a 12x6 on a .20 with good throttling from 1400rpm to 5800rpm and no overheating. Now that is a lugger! Crazy. ...
    417 replies | 24471 view(s)
More Activity
About 1QwkSport2.5r

Basic Information

About 1QwkSport2.5r
Location:
Cottage Grove, MN

Signature


GlowHead Brotherhood #3
Friends don't let friends buy Fox.


Statistics


Total Posts
Total Posts
5,960
Posts Per Day
1.93
General Information
Last Activity
Today 10:14 AM
Join Date
10-15-2006
Referrals
0
All times are GMT -6. The time now is 10:26 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.