AndyKunz AndyKunz is offline

Visitor Messages

Showing Visitor Messages 1 to 2 of 2
  1. RC Wade
    02-19-2019 09:24 PM
    Hi Andy,
    I've read with much interest your December, 09 Kraft radio conversion thread and am hoping you can advise me as I attempt to duplicate your Spektrum DX5e transplant with a slight variation. The difference is my Series Eighty Kraft is a single stick. I was doing fine swapping the three wires from the DX5e pots to their Kraft counterparts until I encountered the separate trim pots for the throttle and elevator channels, each pair with FOUR wires. Maybe I'm getting dense in my old age, but I'm stumped. Can you offer any guidance? I can only offer my undying gratitude in return.
    Thank you!!
    Wade in SoCal


  2. IGOS R/C
    08-22-2017 09:03 AM
    Dear Kunz
    Could you help me on this following question?
    I program a crow in a jet plane with a JR 12X and assign it to the flap switch by means of a prog.mix1. But I would like to keep the flap/elev compensation assign to any other 3 position switch to swap crow or just flap/elev in the same flight. It is possible?
    Thank you.
    Isaac

About Me

  • About AndyKunz
    Location
    White Heath, IL
  • Signature
    Andy Kunz - AMA 46063
    Spektrum Development Team

Statistics

Total Posts
Visitor Messages
General Information
  • Last Activity: Today 05:39 AM
  • Join Date: 06-20-2005
  • Referrals: 0

Friends

Showing Friends 1 to 2 of 2

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service