Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Tab Content
  • SJN's Avatar
    05-19-2015, 09:51 PM
    I just finished the Yak-3U, and ready to maiden it. It is a much newer generation of the CY line, and the fit and finish is quite a bit better than...
    98 replies | 13796 view(s)
  • SJN's Avatar
    05-19-2015, 08:05 AM
    SJN replied to a thread EXM SPORT JET in RC Jets
    Honestly, this plane is built like a boat. Just strips of balsa over formers, and then sanded to a smoothe finish, and some spackle, then covered....
    235 replies | 32112 view(s)
  • SJN's Avatar
    05-15-2015, 10:22 AM
    SJN replied to a thread EXM SPORT JET in RC Jets
    I am going to try the retract set from hobbyking. They have a 6mm connecting pin. Have to order some Behotec struts. Thought that I had some that...
    235 replies | 32112 view(s)
  • SJN's Avatar
    05-15-2015, 08:33 AM
    SJN replied to a thread EXM SPORT JET in RC Jets
    Well....Im a sucker for starting too many projects all at the same time..........So not too much actual progress. :D But......the included blue...
    235 replies | 32112 view(s)
  • SJN's Avatar
    05-13-2015, 03:57 PM
    SJN replied to a thread PBR 31MKII in Speed - RC Gas Boats
    Thanks will...still looking for a crew that will not cost more than the boat itself :-)
    11 replies | 1772 view(s)
  • SJN's Avatar
    05-06-2015, 05:13 PM
    I think the germans removed the siren on this version of the full size Stuka :-) Bought mine here:...
    37 replies | 8646 view(s)
  • SJN's Avatar
    05-06-2015, 03:51 PM
    Just started mine up for te first time, and it was so lean that it only ran on one cylinder. Waiting for better weather to get out and run in the...
    46 replies | 2933 view(s)
  • SJN's Avatar
    05-06-2015, 04:30 AM
    Anyone still flying their Stuka ? I jost got one, and in the assembly process. Is the CG at 10cm from the leading edge good ? Great looking...
    37 replies | 8646 view(s)
No More Results
About im4rc

Basic Information

Date of Birth
January 1 (115)
About im4rc
Location:
peachtree city, GA

Signature


josh thorner
770-487-9569

Statistics


Total Posts
Total Posts
27
Posts Per Day
0.01
General Information
Last Activity
05-06-2015 03:30 PM
Join Date
07-04-2002
Referrals
0
All times are GMT -6. The time now is 11:46 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.