Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Tab Content
  • JSF-TC's Avatar
    Yesterday, 06:12 AM
    I started flying my new Ultra Flash last year with a Wren SuperSport (17lb), and put ~50 flights on it before upgrading to a Merlin 140XBL (31lb). ...
    5705 replies | 920893 view(s)
  • JSF-TC's Avatar
    Yesterday, 03:09 AM
    Tom, Yes - TM becomes available via RX2. You do lose the ability to see the CB200 in Device Explorer though. You have to bypass the gyro...
    138 replies | 11272 view(s)
  • JSF-TC's Avatar
    03-21-2017, 06:56 AM
    Will, When I install my inlet transition duct I find it easiest to put my hand inside the duct from the rear to help the front end expand slightly...
    5705 replies | 920893 view(s)
  • JSF-TC's Avatar
    03-15-2017, 05:52 AM
    Yes, it works just fine, if not bothered about telemetry. Paul
    138 replies | 11272 view(s)
  • JSF-TC's Avatar
    03-13-2017, 05:17 AM
    JSF-TC replied to a thread Jeti-duplex-ds-16-2.4-ghz in RC Jets
    Ceeray, Run the throttle from one of the remote receiver channels - it will only draw minimal current, and won't change under load like a servo...
    3068 replies | 207291 view(s)
  • JSF-TC's Avatar
    03-07-2017, 01:18 PM
    Thanks for the suggestions - my suspect was contamination also. I did have to put some petroleum grease on the air trap filter seal to stop it...
    6 replies | 558 view(s)
  • JSF-TC's Avatar
    03-06-2017, 08:01 PM
    I'm repairing a minor wingtip ding on my Ultra Flash after I shut it in the car door, and I ordered all the matching CARF touch-up colors and...
    6 replies | 558 view(s)
  • JSF-TC's Avatar
    03-06-2017, 06:40 PM
    JSF-TC replied to a thread DerJet Hunter here! in RC Jets
    Good suggestions - I don't think so but worth checking. Can't do anything more right now as my gear is with Darrell at Sierra to get the extended...
    93 replies | 13776 view(s)
  • JSF-TC's Avatar
    03-06-2017, 01:49 PM
    JSF-TC replied to a thread DerJet Hunter here! in RC Jets
    Yes, UP-3 needles opened almost all the way - nothing snappy about the mains retracting, but they come down positively. They struggle to get past...
    93 replies | 13776 view(s)
  • JSF-TC's Avatar
    03-06-2017, 01:09 PM
    JSF-TC replied to a thread DerJet Hunter here! in RC Jets
    As for c.g., I'm flying it now about 10mm in front of the recommended most-forward position from the manual. It is much more solid on approach and it...
    93 replies | 13776 view(s)
  • JSF-TC's Avatar
    03-06-2017, 01:05 PM
    JSF-TC replied to a thread DerJet Hunter here! in RC Jets
    Dave, I'm using a UP-3 valve. I have even drilled out the nipples on the UP-3 (after removing them from the valve!) to get more flow through it. ...
    93 replies | 13776 view(s)
  • JSF-TC's Avatar
    03-06-2017, 11:57 AM
    JSF-TC replied to a thread DerJet Hunter here! in RC Jets
    Dave, Can you take a photo of the main gear from directly behind. My main legs are splayed out 6degrees. I mentioned it to DerJet and they just...
    93 replies | 13776 view(s)
  • JSF-TC's Avatar
    03-06-2017, 10:44 AM
    Or just plug the RX1 receiver through the Cortex Pro and run the RX2 receiver direct to the CB200, bypassing the gyro. The system will default to...
    138 replies | 11272 view(s)
  • JSF-TC's Avatar
    03-03-2017, 10:06 AM
    JSF-TC replied to a thread Jeti-duplex-ds-16-2.4-ghz in RC Jets
    The loss of all antenna info if you unplug one of the Rx in dual path mode is a known issue. Paul
    3068 replies | 207291 view(s)
  • JSF-TC's Avatar
    03-02-2017, 04:08 AM
    Yes, they are 1/8th fittings. Originally I ordered the 3/16" but agree they are huge. Needs 8mm fuel tubing. Unfortunately my first tank order...
    5705 replies | 920893 view(s)
  • JSF-TC's Avatar
    03-01-2017, 05:52 PM
    Paul, Thanks. Those are the smaller Jet tech saddle tanks, so trimming off the seam was not really required - I did it just for neatness before...
    5705 replies | 920893 view(s)
  • JSF-TC's Avatar
    03-01-2017, 04:47 PM
    William, Photos of my Ultra Flash saddle tank installation and fuel line routing. The saddle tank vent lines run forward to a Festo T and then...
    5705 replies | 920893 view(s)
  • JSF-TC's Avatar
    03-01-2017, 09:20 AM
    I made a small mini-bulkhead attached to the fuselage at the front of the tank with a cutout in it to hold around the tank fitting, and added a ply...
    5705 replies | 920893 view(s)
No More Results
About JSF-TC

Basic Information

Date of Birth
May 29, 1967 (49)
About JSF-TC
Location:
Fort Worth, TX

Statistics


Total Posts
Total Posts
581
Posts Per Day
0.11
General Information
Last Activity
Today 11:36 AM
Join Date
05-25-2002
Referrals
0
RCU Reviews
All times are GMT -8. The time now is 09:33 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.