Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Tab Content
  • Dave Wilshere's Avatar
    12-24-2014, 01:45 AM
    Dan I have just emailed you back. GJC should be able to sort you out. Dave
    1074 replies | 111351 view(s)
  • Dave Wilshere's Avatar
    12-22-2014, 04:43 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Little Stevie (my usual flight photographer) always seems to catch some good shots...sure its just my camera and model positioning ;-) Seems a but...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-22-2014, 04:36 PM
    The rear holes have been the same since the first Flash, if they open the hole nearer perfect, more chance of the top seam cracking during transport....
    4601 replies | 639771 view(s)
  • Dave Wilshere's Avatar
    12-21-2014, 07:34 AM
    Long and thin?
    42 replies | 1269 view(s)
  • Dave Wilshere's Avatar
    12-21-2014, 07:29 AM
    Mmm don't have camera card here showing the work, but here is a picture showing the start of the line I would dremel to. The top (bottom on this...
    4601 replies | 639771 view(s)
  • Dave Wilshere's Avatar
    12-21-2014, 05:29 AM
    You are just making work! The tail cone tab will need cutting down (especially when you open the back of the fuselage opening towards the top like it...
    4601 replies | 639771 view(s)
  • Dave Wilshere's Avatar
    12-21-2014, 05:25 AM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Plenty!
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-21-2014, 04:24 AM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Shortest I have flown it off is a 60m helicopter club strip. With a breeze its easy, with no wind its about the limit. Dave
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-20-2014, 03:25 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Looks good! Was asked to test fly an old/new Habu 32 P-20SX today. even on rough grass it coped well. No CROW on this one. When back in the...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-20-2014, 01:58 PM
    Mike Cool, after all, the schemes were devised for your market :-) Yes, the other schemes are still available, plan was just to add schemes...
    1074 replies | 111351 view(s)
  • Dave Wilshere's Avatar
    12-19-2014, 03:45 PM
    I really like the BA, the Flash and UF in that scheme is very over looked! I just decided I'd build a new Xcalibur next year and pick one :-) I...
    1074 replies | 111351 view(s)
  • Dave Wilshere's Avatar
    12-19-2014, 03:30 PM
    The new schemes are inbound! They arrive in the UK in Jan and elsewhere in the World not long after :-)
    1074 replies | 111351 view(s)
  • Dave Wilshere's Avatar
    12-19-2014, 12:36 PM
    Sorry, been a bit mad here today getting everything out in time for Xmas. As JJP said, it comes like this Dave
    24 replies | 1404 view(s)
  • Dave Wilshere's Avatar
    12-19-2014, 04:37 AM
    We have our first delivery :-)
    24 replies | 1404 view(s)
  • Dave Wilshere's Avatar
    12-16-2014, 02:59 PM
    You can use it with an S-Bus Rx, but need std Digital servos. The iGyro 3e is here for simple installations without a Bus system
    38 replies | 2031 view(s)
  • Dave Wilshere's Avatar
    12-16-2014, 06:58 AM
    If CJ is the maiden we can talk through movements and I can even spot for you. Elevator I usually have more expo on down than up by 5% and I'd punch...
    4601 replies | 639771 view(s)
  • Dave Wilshere's Avatar
    12-16-2014, 02:04 AM
    Dom All comes down to what you want from the airframe, do you like sharp, soft, responsive, F3a! For you go back to 230-235mm on balance. Some...
    4601 replies | 639771 view(s)
  • Dave Wilshere's Avatar
    12-15-2014, 02:59 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    I do use that much flap and only 1/8" CROW..the wing is small enough as it is without dumping a whole load more lift! With the stock horn layout you...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-14-2014, 01:51 PM
    You can go back.My "safe" position for first time UF drivers is conservative. Having been there, I'd go 232mm straight off. Dave
    4601 replies | 639771 view(s)
  • Dave Wilshere's Avatar
    12-13-2014, 05:17 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    OK, finally had a little time today, started looking at wings, one of the things I did on the first one was angle back the flap horns. As designed...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-13-2014, 02:31 PM
    http://www.rcuniverse.com/forum/rc-jets-120/11594024-carf-eurosport-details.html
    42 replies | 1269 view(s)
  • Dave Wilshere's Avatar
    12-11-2014, 09:48 AM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    You go for their stock 30c packs too? 150mph or there abouts. We had some Tams legs and I thought the stock wire was better on grass. Dave
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-10-2014, 01:21 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Cell number still does not say capacity! It could be 12s 2700's (unlikely) I have flown a couple of Habu 32's and thought they were all a little...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-10-2014, 11:09 AM
    Josh I'm a big Powerbox fan, but the UF does not need one, its just weight. We designed the wood to take the Sensor switch with two 2200 Li-Pos...
    4601 replies | 639771 view(s)
  • Dave Wilshere's Avatar
    12-10-2014, 01:55 AM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    No way of measuring it, but it lands slow enough with fill flap, some CROW (3mm) Biggest thing is the flap control set up is poor, the way they show...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-09-2014, 03:47 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Yeh, mine was OK, I know a few were that dry...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-09-2014, 02:28 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    I don't have it anymore, but I'd say wet was around 8lb. I know some of the conversions done were heavy with moulded tanks and double walled tail...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-09-2014, 12:10 PM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    As far as structural integrity, no worries. It was obviously designed by someone who knew what they were doing, EDF and turbine are similar OA...
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-09-2014, 02:28 AM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Here is another that HH UK did, but not a complete flight. www.youtube.com/watch?v=TKaRGyhGEpE
    47 replies | 2921 view(s)
  • Dave Wilshere's Avatar
    12-09-2014, 02:24 AM
    Dave Wilshere replied to a thread Habu 32X in RC Jets
    Wing and tail are different. Stall speed was never a problem on my Habu 32 turbine. Most of the flights I did were on grass. This is a poor video of...
    47 replies | 2921 view(s)
More Activity
About miniman

Basic Information

Date of Birth
January 1 (114)
About miniman
Location:
Wellingborough, UNITED KINGDOM

Statistics


Total Posts
Total Posts
145
Posts Per Day
0.03
General Information
Last Activity
12-22-2014 02:31 PM
Join Date
12-24-2002
Referrals
0
All times are GMT -6. The time now is 12:41 AM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.