Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

Tab Content
  • 1QwkSport2.5r's Avatar
    Today, 11:38 AM
    Glad to hear you're back in action Bob!
    1 replies | 38 view(s)
  • 1QwkSport2.5r's Avatar
    Yesterday, 08:55 AM
    1QwkSport2.5r replied to a thread Club FOX! in Glow Engines
    So yesterday my friend and I made the new heads for low nitro glow fuel for my Fox 1.20 twin. The factory heads (center 2) are setup for 25% nitro...
    3519 replies | 220667 view(s)
  • 1QwkSport2.5r's Avatar
    07-25-2014, 11:19 PM
    No flying for me tomorrow, but I am going to try to run a few engines. My Fox twin has been running in the usual Fox fashion; take 3 gallons to...
    589 replies | 10659 view(s)
  • 1QwkSport2.5r's Avatar
    07-22-2014, 06:36 AM
    That's odd it's gotten goopy on you. I've never had the sensor safe RTV silicon get mushy or goopy. I've used it on many engines too. Maybe I...
    9 replies | 149 view(s)
  • 1QwkSport2.5r's Avatar
    07-21-2014, 05:44 PM
    You guys must have missed the part where the OP said there was not enough tank pressure from his homemade muffler. Plugging a tube cured the...
    32 replies | 602 view(s)
  • 1QwkSport2.5r's Avatar
    07-20-2014, 06:10 AM
    1QwkSport2.5r replied to a thread Club FOX! in Glow Engines
    For its day, the Combat Special .35 is quite impressive. .87bhp is crazy high for a .35 of the era, eh?
    3519 replies | 220667 view(s)
  • 1QwkSport2.5r's Avatar
    07-18-2014, 04:34 PM
    I'd use the black stuff. It's sensor safe and intended for oil pans. I use this or the copper colored stuff. Never had the stuff burn up. The...
    9 replies | 149 view(s)
  • 1QwkSport2.5r's Avatar
    07-18-2014, 06:53 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I'll add a question; do these little .15's prefer to rev like many Enyas? What props are ideal? I'm much more accustomed to larger engines...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-18-2014, 06:40 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I'm eyeing a NIB .15IV and a nearly new .15IV in boxes with carbs and mufflers for cheap right now. If the price stays right, I'll jump on them. I...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-18-2014, 04:58 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    With the head off, the piston will get stuck at TDC. It starts to get snug about 1/8" from the top of the cylinder. Yes I know it's an iron...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-17-2014, 07:30 PM
    Castor is now $40/gal from SIG. I was getting it for $23/gallon for the last few years. Getting spendy.
    18 replies | 284 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 09:49 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    Here is my pair of .15IV's. The one on the left has some time on it, enough to have carbon built up on the piston. The one on the right sans...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 06:39 PM
    Anytime I've used cereal boxes or the like for gasket material, they've leaked. My latest lesson was with my reed valve air compressor. There...
    9 replies | 149 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 10:57 AM
    Being able to open the needle valve 4 turns and it doesn't go rich tells me it's not getting enough fuel. On most carbs, 4 turns out would barely...
    32 replies | 602 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 10:32 AM
    The bearing seal isn't what seals the crankcase, it's the oil film created between the crankshaft and bearing race. If you have a leak at the...
    32 replies | 602 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 09:38 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I know other mufflers will fit but without knowing exactly which ones fit, I don't want to gamble. I found a pair of Enya mufflers on eBay for a...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 05:49 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    If I had a suitable drill press or lathe I'd drill the engine case and bolt a muffler on. Is looks as though it should be drilled, there's an...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 04:44 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    Yeah, for whatever reason the 15 IV is strap on only. Perhaps some of the newer IVs are bolt through. I did tell Ken exactly what I was looking...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-16-2014, 01:59 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I wonder why Ken said they were the same... I was under the impression that the 154 was tapped for bolt-through screws and the 153 just came with...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-15-2014, 07:29 PM
    Burning glow plugs happens from too much nitro for the compression ratio or too lean of fuel mixture. I'll almost guarantee it's the latter. ...
    32 replies | 602 view(s)
  • 1QwkSport2.5r's Avatar
    07-15-2014, 07:27 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I got both engines for less than $35 but without mufflers and 1 carb. I assumed when I bid on the carb-less engine that I could find a used carb...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-15-2014, 07:00 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    Ken Enya said the M154 muffler is what I need but does not come with the strap or screws. The M153 muffler is the same as the M154 but has the strap...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-15-2014, 06:34 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    The mufflers are 17-20$ each from Shtterman, plus the strap and screws are another $5 each muffler. The mufflers with screws/straps from Enya direct...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-15-2014, 03:09 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I will keep that in mind, Jeff. Thanks for the info. I got got a reply back from Ken Enya; the mufflers are about $12/ea (1200JPY) and the...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-14-2014, 09:19 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    Yeah, I'm of the belief to buy something that will last. I don't want any more "cheap" engines. Buying good engines cheaply is different IMO. ...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-14-2014, 08:18 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    No word back from Enya directly, but I got a message back from Shtterman on eBay. $17/ea for mufflers, $24.50/carb and $4/throttle arm that's gonna...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-14-2014, 03:26 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    For whatever reason I'm on an engine buying binge and am eyeing one or two more .15 IV's that are NIB. I'll keep my eyes out for a parts engine...
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-14-2014, 01:57 PM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    And he wants $24.50 for a carburetor and $4 shipping. I think that's a bit steep for a .15 sized carburetor. But that's just me.
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-14-2014, 07:00 AM
    1QwkSport2.5r replied to a thread Club Enya in Glow Engines
    I sent an email shortly after my last post. :)
    2225 replies | 157157 view(s)
  • 1QwkSport2.5r's Avatar
    07-14-2014, 06:58 AM
    No pusher props. Tractor configurations and pistol grip 2.4GHz radios. Have a pleasant day sir.
    28 replies | 719 view(s)
More Activity
About noisy

Basic Information

About noisy
Location:
sydney nsw, AUSTRALIA

Signature


WINNERS \"R\" GRINNERS

Statistics


Total Posts
Total Posts
151
Posts Per Day
0.07
General Information
Last Activity
07-22-2014 09:33 PM
Join Date
09-16-2008
Referrals
0
All times are GMT -6. The time now is 03:01 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.