Register

If this is your first visit, please click the Sign Up now button to begin the process of creating your account so you can begin posting on our forums! The Sign Up process will only take up about a minute of two of your time.

  • Johnny9390's Avatar
    Today, 07:53 AM
    Ok guys lets start over, i will NOT be using the onboard gas canister. I have a one way check valve on the input line of the solenoid to connect...
    7 replies | 106 view(s)
  • Johnny9390's Avatar
    Today, 07:42 AM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    My UAT is mounted right in front of the elevator and rudder servos in the radio bay. I will redo the CG. Just gonna have to find where to add more...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    Yesterday, 09:44 PM
    Ive been reading the manual and forums and have not found straight answer. 1st should the powermax can be held upside down?? External tank direct...
    7 replies | 106 view(s)
  • Johnny9390's Avatar
    Yesterday, 06:54 PM
    Johnny9390 replied to a thread JetLegend Buys BVM in RC Jets
    I just wish the prices would go down a bit. Man these "toys" are expensive no matter who manufactures them.
    71 replies | 7984 view(s)
  • Johnny9390's Avatar
    Yesterday, 04:55 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Will do. I did make the ballast removable for that reason. But if I used 12oz to simulate full UAT and I was way over that means I will be even more...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    Yesterday, 04:24 PM
    Johnny9390 replied to a thread BVM's Big F-86 ARF in RC Jets
    Rav do you have a work shed outside you do all your building or is that a garage? I don't have a garage and most of my building is in the house. Now...
    42 replies | 3951 view(s)
  • Johnny9390's Avatar
    Yesterday, 04:14 PM
    If if you don't have a electrodynamics switch just snip off the signal wire on the plug going to the rx. Either snip it or pull it back and...
    16 replies | 542 view(s)
  • Johnny9390's Avatar
    Yesterday, 04:06 PM
    Johnny9390 replied to a thread JetLegend Buys BVM in RC Jets
    Too bad Patty doesn't keep dads company going and keep it in the family. Dad can just sit back and enjoy his retirement and fly for fun. Let the kids...
    71 replies | 7984 view(s)
  • Johnny9390's Avatar
    Yesterday, 03:57 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Why not just use a 4mm festo filter?
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    Yesterday, 12:51 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    I didnt have any jet a to fill the UAT to I used about 12oz of lead placed right over the UAT and it took about 9oz up in the nose to balance the...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    Yesterday, 12:48 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Ok guys let me know how this looks. I would have had to run a whole new line for the furl so what I did is put a 90 there and now the fuel lines goes...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-23-2016, 09:17 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Just affraid after first flight its gonna look like i have streamers coming ouff the airplane
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-23-2016, 09:13 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Cool doing that now. Bummer bought this jet all built up and gentleman did such a great job on the build i just noticed when i mated the wing to fuse...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-23-2016, 09:08 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-23-2016, 07:49 PM
    Does the pump run? Simulate a start to seemifnthe pump runs if not bad pump
    5 replies | 196 view(s)
  • Johnny9390's Avatar
    05-23-2016, 07:14 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Im confused a little. Direction of fuel flow is forward to aft. My question is the way the fuel plumbing is now sitting on top of wing below the mail...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-23-2016, 06:26 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    When you say mount that filter vertical doesmit matter which side is up or down. If you look at my last picture wouldmit be ok to run the line up and...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-23-2016, 06:21 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    I will be taking it there. Funny ive been flying turbines on and off for years but never got my waiver so might have a friendmfly her around....
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-23-2016, 03:41 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Finished up the radio install and mounted the satellites. Gonna put the wing on and CG it next. Gotta clean up the wiring in the boat tail but I am...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-22-2016, 07:30 PM
    Do you have a GDU for the tems unit?
    5 replies | 196 view(s)
  • Johnny9390's Avatar
    05-22-2016, 07:28 PM
    I agree with you Art. Gonna run her like this. If i have any issues might think of doing the upgrade. Thx Johnny
    5 replies | 110 view(s)
  • Johnny9390's Avatar
    05-22-2016, 07:26 PM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Thanks Art, Yeah i wanted to keep it simple and not tun another two extra wires to the rx. Was a thought ifmi couldnt figure out the programmer....
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-22-2016, 11:50 AM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Yeah the problem is when setting center and endpoints it thinks youre *****g out your endpoints on your trasmitter. So i set my trasmitter to 150% up...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-22-2016, 11:44 AM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Figured it out
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-22-2016, 11:06 AM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    I should have used a smart fly thst would have made it easier but thats why i went hitec servos, so i can use the programmer and Y the flaps and...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-22-2016, 11:05 AM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Anyone here have experience with the hitec servo programmer that can help me setup my flaps. Im matching center and end points using programmer one...
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-22-2016, 06:58 AM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Chic what motor you installing in yours?
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-22-2016, 06:34 AM
    Does anyone have contact info for B1 Bob? Have a few questions for him regarding this F14 . Been watching his video and i think i might have his F14...
    6 replies | 658 view(s)
  • Johnny9390's Avatar
    05-21-2016, 06:27 AM
    Johnny9390 replied to a thread Reaction 54 Jet Kit in RC Jets
    Well i changed the filter just because. Have both so lets see how the jetcat filter works. Always have the festo filter as a backup
    3545 replies | 559010 view(s)
  • Johnny9390's Avatar
    05-20-2016, 09:20 PM
    Anyone know how i can contact Richard Hurtser??? Thanks Johnny9390@gmail.com
    0 replies | 102 view(s)
More Activity
About rocketman-RCU

Basic Information

Date of Birth
January 1 (116)
About rocketman-RCU
Location:
Lawrence, KS

Statistics


Total Posts
Total Posts
202
Posts Per Day
0.04
General Information
Last Activity
05-11-2016 07:08 PM
Join Date
01-15-2002
Referrals
0
RCU Reviews
All times are GMT -6. The time now is 09:37 PM.

SEO by vBSEO 3.6.1 ©2011, Crawlability, Inc.