Go Back  RCU Forums > sheograth
Reload this Page >

Conversation Between sheograth and flako6869

Notices
Conversation Between sheograth and flako6869
Showing Visitor Messages 1 to 1 of 1
  1. 08-13-2016 02:07 PM
    Hi, I just tried to run my Losi DBXL to break it in, but when it starts, it runs away. According to the manual, I should not adjust the carb settings until after it has been broken in. Why is it running away? What can I do to prevent it from running away? It should just idle at a still position, shouldn't it?
    Thank you.

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.