mvvs .77 break in
#1
Thread Starter
My Feedback: (149)
mvvs .77 break in
Hi All,
Have recenntly acquired a new .77 that didn't come with box or any instructions. I plan to use 5% nitro with 20% oil (50/50 mix synthetic and castor) and suspect it will be a slow break in process. Will probably wind up in a Golden Age relic with a big prop but mabey a 4*60 to get some time in.
Any info on break in procedures, prop sizes, and ADVICE or sugestions are apprecated.
Many Thanx
T-man49 in Alabama
Club Saito 723
Have recenntly acquired a new .77 that didn't come with box or any instructions. I plan to use 5% nitro with 20% oil (50/50 mix synthetic and castor) and suspect it will be a slow break in process. Will probably wind up in a Golden Age relic with a big prop but mabey a 4*60 to get some time in.
Any info on break in procedures, prop sizes, and ADVICE or sugestions are apprecated.
Many Thanx
T-man49 in Alabama
Club Saito 723
#5
Thread Starter
My Feedback: (149)
RE: mvvs .77 break in
Hi 4*60,
Do understand and appreciate your opinion here. I do have a 4*60 on the build table rite now to use as a test bed for most of my smaller engines . . . specifically for reasons you mentioned.
Again, Many Thanx for your input
Mike Brennan
T-man49 in AL
Do understand and appreciate your opinion here. I do have a 4*60 on the build table rite now to use as a test bed for most of my smaller engines . . . specifically for reasons you mentioned.
Again, Many Thanx for your input
Mike Brennan
T-man49 in AL