MVVS 35cc: fitting MVVS tuned pipe and header
#1
Member
Thread Starter
Join Date: Nov 2011
Location: NottinghamNottinghamshire, UNITED KINGDOM
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
MVVS 35cc: fitting MVVS tuned pipe and header
Can anyone help with the approximate fitting length of the MVVS35cc / tuned pipe and header. Even better, the best way to fit and determine correct position within the airframe ?
thanks
Bob V
thanks
Bob V
#2
Senior Member
Join Date: Jan 2002
Location: Arcen, , NETHERLANDS
Posts: 6,571
Likes: 0
Received 2 Likes
on
2 Posts
RE: MVVS 35cc: fitting MVVS tuned pipe and header
The MVVS 3268 tuned pipe has the 9" long header 3269 paired to it. This is best for standard use.
Fitting in the fuselage IMHO does not belong to MVVS support, but is a question of general nature.
However, having said that, the pipe runs straight under the engine Center line with the cylinder fitted in the 7:30 o'clock position.
Fitting in the fuselage IMHO does not belong to MVVS support, but is a question of general nature.
However, having said that, the pipe runs straight under the engine Center line with the cylinder fitted in the 7:30 o'clock position.
#3
Member
Thread Starter
Join Date: Nov 2011
Location: NottinghamNottinghamshire, UNITED KINGDOM
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
RE: MVVS 35cc: fitting MVVS tuned pipe and header
Thanks PE,
Do I need to cut/remove any of the header pipe to find the optimum 'tuning length' or is it manufactured at that 'specific' length?
Bob V