Piper PA 18 Super Cub #3106
#1
Junior Member
Thread Starter
My Feedback: (10)
Join Date: Jan 2009
Location: Lincoln,
CA
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Piper PA 18 Super Cub #3106
I have just finished a 50 year old Cub that I purchashed at an estate sale. It was made in germany by robbe. It has a 83" wing span w/ ailerons and flaps. The wing is 12" wide.
recommended weigt is 9.2lbs. I need advise on where to set the center of gravity. Also my finished weigt is 10.4 lbs. The recommend 2 cycle engine is .40. I have installed an Evolution
46NT but I am not sure what size prop to use or if the engine is enough to fly this over-weight
puppy. Please advise.
Richard
recommended weigt is 9.2lbs. I need advise on where to set the center of gravity. Also my finished weigt is 10.4 lbs. The recommend 2 cycle engine is .40. I have installed an Evolution
46NT but I am not sure what size prop to use or if the engine is enough to fly this over-weight
puppy. Please advise.
Richard
#2
RE: Piper PA 18 Super Cub #3106
Hi
This is the wrong forum for this question.
This forum is for planes sold by www.nitroplanes.com
You may want to delete this thread and report on one of the other forums.
This is the wrong forum for this question.
This forum is for planes sold by www.nitroplanes.com
You may want to delete this thread and report on one of the other forums.