Park Flyers & Backyard Flyers Discuss RC Parkflyers and rc backyard flyers in this forum

Micro F86 radio problems

Reply
Old 06-16-2013, 03:59 PM
  #1
edgeflyer
Thread Starter
 
Join Date: Jun 2002
Location: TX
Posts: 367
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default Micro F86 radio problems

Setup a electrifly micro saber about 3 months ago. Finally got around to flying it and it wouldn't connect to my 12X. Like I said, it has worked with this radio. I plug the trainer jack in on the anylink, then the battery lead, then plug the plane in. I get power on the anylink and a beep. I just get a rapid flash on the receiver. Any ideas?
edgeflyer is offline  
Reply With Quote
Old 06-19-2013, 05:02 AM
  #2
Steve Percifield
 
Steve Percifield's Avatar
 
Join Date: Feb 2002
Location: Noblesville, IN
Posts: 1,439
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Micro F86 radio problems

//
Steve Percifield is offline  
Reply With Quote
Old 06-19-2013, 05:04 AM
  #3
Steve Percifield
 
Steve Percifield's Avatar
 
Join Date: Feb 2002
Location: Noblesville, IN
Posts: 1,439
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Micro F86 radio problems

we have found that sometimes location affects the binding. Try moving farther away, and even a different room. If it's close to another 2.4 source, it won't link. Also, I'll state the obvious, you left the tranny switch off, right ??

one of my warbirds lost the link in a gym we were using and wouldn't relink until I got home.
Steve Percifield is offline  
Reply With Quote
Old 06-20-2013, 08:26 AM
  #4
edgeflyer
Thread Starter
 
Join Date: Jun 2002
Location: TX
Posts: 367
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: Micro F86 radio problems

I will retry tonight at home. Thanks
edgeflyer is offline  
Reply With Quote
Reply


Thread Tools
Search this Thread
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



All times are GMT -8. The time now is 12:52 PM.