Pop'n The bubblies. Quench your need for speed (Python P-51 Reno Racer)
#1
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Fremont, CA.
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Pop'n The bubblies. Quench your need for speed (Python P-51 Reno Racer)
Here's my new P-51 Reno Racer. by Mark Rittinger, sold and lazer cut by Andy Kunz @ http://www.flyinghobbies.com/ , thanks to the designer and to the one that made it available to all, Andy Kunz
Model: Mark Rittinger's, Python.
I built the model per plan, but modified the bottom by inserting a wooden dowel, so I can easly take it off for transport. As side for that, that the only mod. that I did to this plane.
Specs:
Wing Span - 29"
Wing Area - 156 sq in
Wing Loading - 14-17 oz/sq ft
Weight - 14-18 oz
Motor - 6V Speed 400
Cells - 7 or 8, 600 to 800 mAH
Radio - 2-4 channels
My setup:
Motor: Mega x3t
Prop: 4.75x4.75
Rx: HS 555
Servo: 2 HS 55s
Bat: 8cell/1100 HeCells.
----Maiden Flight Sunday
Model: Mark Rittinger's, Python.
I built the model per plan, but modified the bottom by inserting a wooden dowel, so I can easly take it off for transport. As side for that, that the only mod. that I did to this plane.
Specs:
Wing Span - 29"
Wing Area - 156 sq in
Wing Loading - 14-17 oz/sq ft
Weight - 14-18 oz
Motor - 6V Speed 400
Cells - 7 or 8, 600 to 800 mAH
Radio - 2-4 channels
My setup:
Motor: Mega x3t
Prop: 4.75x4.75
Rx: HS 555
Servo: 2 HS 55s
Bat: 8cell/1100 HeCells.
----Maiden Flight Sunday
#2
Senior Member
Thread Starter
Join Date: Nov 2002
Location: Fremont, CA.
Posts: 162
Likes: 0
Received 0 Likes
on
0 Posts
Pop'n The bubblies. Quench your need for speed (Python P-51 Reno Racer)
I still need to finalize the side of the fuse, with some add trims, to that, I don't know yet, but will find a good trim.. Thinking of Yellow/with flame scheme. HUMMMM????