PZ P51 Brushless Conversion
#1
Member
Thread Starter
Join Date: Oct 2002
Location: WI
Posts: 38
Likes: 0
Received 0 Likes
on
0 Posts
PZ P51 Brushless Conversion
Has anyone replaced the stock electronics on the Parkzone P51 with a brushless setup yet? What equipment did you use? Did you reinforce the firewall anyhow?
#2
Senior Member
Join Date: Sep 2004
Location: Anchorage,
AK
Posts: 645
Likes: 0
Received 0 Likes
on
0 Posts
RE: PZ P51 Brushless Conversion
Ya. GlacierGirl has converted a PZ P-51D to brushless and he dropped in a retractable landing gear for good measure. I also think that there is a thread discussing this but cannot find it.
#3
My Feedback: (4)
Join Date: Jul 2004
Location: Lakeland,
FL
Posts: 7,906
Likes: 0
Received 0 Likes
on
0 Posts
RE: PZ P51 Brushless Conversion
gilligan,
I run a Mega 16/15/6 on 4s1320 lipo. Spinning a 4 blade prop.
Like Fisher said I went all out, installing retractable landing gear and tail wheel steering.
So a little reading in the big Mustang forum here, and you can find a lot of good tips on setting this up. One of the biggies is foaming the nose to strengthen it.
I run a Mega 16/15/6 on 4s1320 lipo. Spinning a 4 blade prop.
Like Fisher said I went all out, installing retractable landing gear and tail wheel steering.
So a little reading in the big Mustang forum here, and you can find a lot of good tips on setting this up. One of the biggies is foaming the nose to strengthen it.