Mini Ultra Stick - rudder
03-25-2006, 10:10 PM
#1
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Dec 2002
Location: OKC, OK
Posts: 925
Likes: 0
Received 0 Likes
on
0 Posts
Mini Ultra Stick - rudder
Hey there guys. I'm finally finishing up my E-flite Mini Ultra Stick (really, can anyone get these arf's together as fast as they say???) and I just happened to notice that the rudder is twisted. The top of it sticks out past the vert. stab about 1/4" when the bottom is directly in line with it. Any suggestions on the best way to get this thing lined up?
Thanks in advance.
Beardking
Thanks in advance.
Beardking
03-26-2006, 10:08 PM
#4
Senior Member
Thread Starter
My Feedback: (4)
Join Date: Dec 2002
Location: OKC, OK
Posts: 925
Likes: 0
Received 0 Likes
on
0 Posts
RE: Mini Ultra Stick - rudder
Bevo,
Your suggestion did the trick. I heated up the opposite side with my wife's blow dryer (couldn't find my heat gun in the den, need to clean that place) and it pulled itself back in alignment. Now, I just need a nice day with not so much freaking wind and I'll be back in the air (been grounded for about 1 1/2 years now)
Your suggestion did the trick. I heated up the opposite side with my wife's blow dryer (couldn't find my heat gun in the den, need to clean that place) and it pulled itself back in alignment. Now, I just need a nice day with not so much freaking wind and I'll be back in the air (been grounded for about 1 1/2 years now)
