Tracker III programing
#1
Thread Starter
Tracker III programing
What I want to do I dont think can be done.
Maybe someone has some suggestions.
I have had this tracker for years and love it. I do and have programed some functions like flap, flaperon, elevons and switch assignments. so I have been racking my brain (not much there) to do the folloiwng:
I have a plane set up for elevons, all is fine there. What I now wish to do is add just a little up elevator during the launch of the plane and then take it out once in flight. This would be kinda like reverse flaps (I thought)
To set up the flapperon you must select this in the wing mix selection, but I have elevons selected so I can't go that way.
I have mixed channel 1 and 6 and assigned it to a switch and this works fine but only 1 servo is activated.
I then tried to mix1 with chan 1 and 6, mix2 with chan 2 and 6, assign them both to one switch (A) and still only 1 servo (chan 1) is activated. Both mix's are set up the same as far as percentages of mix.
Now my brain is fried[&o]
Any suggestions?
Larry
Maybe someone has some suggestions.
I have had this tracker for years and love it. I do and have programed some functions like flap, flaperon, elevons and switch assignments. so I have been racking my brain (not much there) to do the folloiwng:
I have a plane set up for elevons, all is fine there. What I now wish to do is add just a little up elevator during the launch of the plane and then take it out once in flight. This would be kinda like reverse flaps (I thought)
To set up the flapperon you must select this in the wing mix selection, but I have elevons selected so I can't go that way.
I have mixed channel 1 and 6 and assigned it to a switch and this works fine but only 1 servo is activated.
I then tried to mix1 with chan 1 and 6, mix2 with chan 2 and 6, assign them both to one switch (A) and still only 1 servo (chan 1) is activated. Both mix's are set up the same as far as percentages of mix.
Now my brain is fried[&o]
Any suggestions?
Larry
#2
Thread Starter
RE: Tracker III programing
NEVER MIND
I had a blonde moment... It works now.......
I now have 2 mixes set to the same switch and percentages master/slave set correctly.
Should work like a dream
Larry
I had a blonde moment... It works now.......
I now have 2 mixes set to the same switch and percentages master/slave set correctly.
Should work like a dream
Larry
#4
Thread Starter
RE: Tracker III programing
Ok, I know that if you dont use something every day you forget how to do it.
As stated before I wanted to program some up elevator to keep my Parkzone F-27 Stryker from diving upon release. The last time I flew it I moved my trim tab all the way down to get it climbing and then with both hands on the TX, retrim during flight.
What I ended up doing was:
1. smix-1, channel 1 (master) and 6 (slave) on the screen that shows M
As stated before I wanted to program some up elevator to keep my Parkzone F-27 Stryker from diving upon release. The last time I flew it I moved my trim tab all the way down to get it climbing and then with both hands on the TX, retrim during flight.
What I ended up doing was:
1. smix-1, channel 1 (master) and 6 (slave) on the screen that shows M