servo buss
#8
Senior Member
Join Date: Jan 2007
Location: Lancaster,
NY
Posts: 1,550
Likes: 0
Received 0 Likes
on
0 Posts
RE: servo buss
Can you swap the RX out and see what happens? It is not likely that all the servos are bad. Another thought; were all the servos set to nuetral position when you hooked the control rods?
#10
Senior Member
Join Date: Jan 2007
Location: Lancaster,
NY
Posts: 1,550
Likes: 0
Received 0 Likes
on
0 Posts
RE: servo buss
Are you over powering the servos? Meaning 6 volts on servos that can only take 5 volts? If none of the conditions mentioned so far exist there is probably nothing to worry about if they seem to work properly.