Spektrum dx7 question
#1
Thread Starter
My Feedback: (15)
Join Date: Jan 2010
Location: Mechanicsburg,
PA
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
Spektrum dx7 question
hello. all. i went today and bought a dx7. now, one question. i bought a used one, and was wondering. can you erase everything, and make it like out of the box? if so, how? right now, it has 11 models on it, and i just want to erase all of them and start over. thanks for any help.
Todd
Todd
#2
Senior Member
My Feedback: (1)
Join Date: Mar 2010
Location: Las Vegas,
NV
Posts: 1,278
Likes: 0
Received 0 Likes
on
0 Posts
RE: Spektrum dx7 question
Page 40 of the manual. Not page 40 of the PDF. I think its page 19 on the PDF. Model reset. You have to do each model. It will only take a couple of min to do them all. Scoot.
http://www.spektrumrc.com/ProdInfo/Files/DX7_Manual.pdf
http://www.spektrumrc.com/ProdInfo/Files/DX7_Manual.pdf
#3
Thread Starter
My Feedback: (15)
Join Date: Jan 2010
Location: Mechanicsburg,
PA
Posts: 353
Likes: 0
Received 0 Likes
on
0 Posts
RE: Spektrum dx7 question
thanks for the help. i skimmed through the instructions, and cant believe i missed that. i think i did it right, all the memory sets had a plane name, and when i hit reset, the name was gone. i hope i did it right. tomorrow, im going to bind my receiver. thanks again for the help.
#4
My Feedback: (1)
Join Date: Apr 2009
Location: washington twp.,
MI
Posts: 890
Likes: 0
Received 0 Likes
on
0 Posts
RE: Spektrum dx7 question
Just to be on the safe side I would make sure you didn't just remove the model name. I would at least check thru the settings of one of the models you reset to make sure everything is back to the defaults.