Ailevator with Futaba 2.4 has me stumped!
#1
Junior Member
Thread Starter
Join Date: Oct 2011
Location: , NV
Posts: 26
Likes: 0
Received 0 Likes
on
0 Posts
Ailevator with Futaba 2.4 has me stumped!
I am trying to set up a dual elevator with two servos using my Futaba 7C 2.4 ghz, but I am unable to figure out how to prevent the elevators from moving with the ailerons. I am able to make the elevators move together and in the correct direction-no problem. I have accessed the ailevator function and tried all kinds of combinations, but I can't prevent the thing from moving each elevator (left and right) with the ailerons.
I have read several posts and everyone says something about 'zero ing' out the ailerons, but I don't know how to do that. I have studied the manual, but it doesn't help much either. Help! Unfortunately, I need kind of a step-by-step set of directions. I appreciate anyone's assistance.
I have read several posts and everyone says something about 'zero ing' out the ailerons, but I don't know how to do that. I have studied the manual, but it doesn't help much either. Help! Unfortunately, I need kind of a step-by-step set of directions. I appreciate anyone's assistance.
#2
Join Date: Sep 2006
Location: The Sunshine state, when it's not raining!
Posts: 8,131
Likes: 0
Received 2 Likes
on
2 Posts
RE: Ailevator with Futaba 2.4 has me stumped!
Try posting your question here http://www.rcuniverse.com/forum/forumid_125/tt.htm This is the Futaba help section.