Nose cone backplate fitting?
#1
Member
Thread Starter
Join Date: Jun 2013
Location: Corvallis, OR
Posts: 53
Likes: 0
Received 0 Likes
on
0 Posts
Nose cone backplate fitting?
I have a Dave Brown nose cone and the backplate hole is larger by a couple mm than the prop drive it sits on. Does anyone have a good technique for centering the backplate so it fits snug and is balanced? Or is there another part I need to procure?
Thanks,
Burt Reynolds
Thanks,
Burt Reynolds
#2
My Feedback: (29)
Burt, I have done the quick and dirty and simply put some heat shrink tube on the shaft. That being said, the spinner should have come with 4 different size sleeves. You can contact DB to get them or you can find an electric pilot that will have some sitting around that came with his APC E prop.