p3arljam

My Feedback: (5)

I have a Spektrum DX9 and a AR 7350 RX and trying to get my Tech aero IBEC working. I have the IBEC plugged into channel 7 (aux 2) . I assigned switch "A" to aux 2 and the switch is working in the servo monitoring screen. I turn the TX and RX on the LED on the IBEC comes on and when i flip the switch either way nothing happens. I am at a loss if anyone can help.


Thanks

RBACONS

My Feedback: (3)

Did you adjust the aux channel endpoints to their maximum and zero out the sub trim as stated in the user instructions?

p3arljam

My Feedback: (5)

Yes I did that and I am using a A123 6.6v battery and both jumpers are pulled off the IBEC

RBACONS

My Feedback: (3)

I would surmise that you're not really plugged into AUX2. Try plugging the IBEC into one of the other channels (like rudder) to verify if it is the IBEC or the receiver that is the source of the issue.

BarracudaHockey

My Feedback: (11)

Did you not get this sorted yet? I know Andy K was helping with this on RCG