Wing for a Midwest Cap 232
#1
Thread Starter
My Feedback: (34)
Join Date: Mar 2002
Location: New Hill, NC
Posts: 230
Likes: 0
Received 0 Likes
on
0 Posts
Wing for a Midwest Cap 232
Any ideas on where I can get a wing for the larger version of the Midwest Cap 232? Mice took up residence in my wing while it was in storage and now it is shot. I'd rather not pay a bundle for a new kit as I just need the wing. Will anyone elses 80" Cap wing fit this thing? If I can't find a wing, I'll probably just end up scrapping it.
Thanks in advance!
Thanks in advance!
#2
My Feedback: (1)
Join Date: Mar 2005
Location: Farmington,
WV
Posts: 635
Likes: 0
Received 0 Likes
on
0 Posts
RE: Wing for a Midwest Cap 232
Shepard,
Have you tried calling Midwest? They were pretty good about getting me some spare parts for my 80 inch Cap project... They problably would have to cut a one off run so you may have to wait a week extra it couldn't hurt to ask...
Good Luck,
Hibrass
Have you tried calling Midwest? They were pretty good about getting me some spare parts for my 80 inch Cap project... They problably would have to cut a one off run so you may have to wait a week extra it couldn't hurt to ask...
Good Luck,
Hibrass