TT 5.5 Spinner
#1
Member
Thread Starter
My Feedback: (11)
Join Date: Dec 2002
Location: Knightdale, NC
Posts: 31
Likes: 0
Received 0 Likes
on
0 Posts
TT 5.5 Spinner
Hi guys, I need to tap your expertise again. I'm looking at a TT 5.5" TT spinner cut for a 20x8 four blade prop. I have Pica 1/5 scale Mustang. I'm looking at a DA-50 or a Moki 2.1 for power.
Is either one of these engines capable of turning this prop with
enough authority to duplicate scale flight. Thanks for your input.
Jimstro
Is either one of these engines capable of turning this prop with
enough authority to duplicate scale flight. Thanks for your input.
Jimstro
#2
Senior Member
Join Date: Dec 2001
Location: Leesburg, GA
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
TT 5.5 Spinner
Hi Jimstro,
IMO neither engines will fill the bill as I know, I'm running ZDZ 60's with the same size props and barely makes scale flight and only at full bore, two blades another story.
I had Dave Brown make my 5.5" spinner with some modification's for less than half the cost on TT.
Charlie
IMO neither engines will fill the bill as I know, I'm running ZDZ 60's with the same size props and barely makes scale flight and only at full bore, two blades another story.
I had Dave Brown make my 5.5" spinner with some modification's for less than half the cost on TT.
Charlie