Go Back  RCU Forums > RC Airplanes > Questions and Answers
Reload this Page >

Engine incidences for a chipmunk

Community
Search
Notices
Questions and Answers If you have general RC questions or answers discuss it here.

Engine incidences for a chipmunk

Thread Tools
 
Search this Thread
 
Old 07-08-2010, 10:16 PM
  #1  
javier figueroa
Junior Member
Thread Starter
 
Join Date: Sep 2006
Location: Minneapolis, MN
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Default Engine incidences for a chipmunk

What are the recomended engine incidences for a WM super chiupmunk 90? It has a OS 90 four stroke and it has a trend to climb . Thanks!!!
Old 07-08-2010, 10:20 PM
  #2  
Gray Beard
My Feedback: (-1)
 
Join Date: Apr 2003
Location: Hemderson, NV
Posts: 14,396
Likes: 0
Received 7 Likes on 7 Posts
Default RE: Engine incidences for a chipmunk

I always set everything without thrust then change as needed. That climb may be wing incidence, CG, stab incidence as well as engine thrust.
Old 07-09-2010, 10:55 PM
  #3  
javier figueroa
Junior Member
Thread Starter
 
Join Date: Sep 2006
Location: Minneapolis, MN
Posts: 3
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Engine incidences for a chipmunk

Thank you for your note.

Could you please help me to understand how the CG can affect the climb? Thanks again!!
Old 07-10-2010, 07:54 AM
  #4  
DavidAgar
My Feedback: (108)
 
DavidAgar's Avatar
 
Join Date: Dec 2001
Location: Battle Ground, WA
Posts: 5,053
Likes: 0
Received 7 Likes on 7 Posts
Default RE: Engine incidences for a chipmunk

Tail draggers usually have 2 degrees of right in them to compensate for engine torque. You could put in 2 degrees of down and give it a try. The CG effects the plane by making it go up and down. Nose heavy will make it fall and tail heavy will make it climb, but tail heavy will also usually effect your flight controls as well. Balance the plane again and if it is right on, then put a couple of washers on the top motor mount screws and see if that helps. Good Luck, Dave
Old 07-10-2010, 08:55 AM
  #5  
Lnewqban
 
Lnewqban's Avatar
 
Join Date: Apr 2007
Location: South Florida
Posts: 4,057
Received 0 Likes on 0 Posts
Default RE: Engine incidences for a chipmunk

javier,

This chart will guide you to determine if your model has a thrust angle problem or not:

http://nsrca.us/all/flying/177-trimchart.html

Without any power (engine off), the tendency to claim depends only on the relation between CG location, decalage and/or elevator trim:

http://www.charlesriverrc.org/articl...GMarkDrela.htm

http://fatlion.com/sailplanes/decalage.html


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.