Questions and Answers If you have general RC questions or answers discuss it here.

9C Prgramming: Flaps/Elevator

Reply

Old 08-10-2010, 01:08 PM
  #1  
mmiller1
Thread Starter
My Feedback: (75)
 
Join Date: Dec 2003
Location: tacoma, WA
Posts: 180
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default 9C Prgramming: Flaps/Elevator

I have had a heck of a time getting Flaps and down elevator with my U.Stick 120. I have tried following FAQ on Futaba's site. I called tech. for verbal help. The guy said go to FAQ because he did not know how to do it. Some support. If someone can help a senior get through his (assumably simple) procedure that would be great. In fact, I would even call you so I could be talked through it. That may be faster.
Thank you.
Tim Miller
Tacoma, WA
mmiller1 is offline  
Reply With Quote
Old 08-10-2010, 05:48 PM
  #2  
Charlie P.
 
Charlie P.'s Avatar
 
Join Date: Feb 2003
Location: Port Crane, NY
Posts: 5,088
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: 9C Prgramming: Flaps/Elevator

Assuming you have two aileron and two flap servos and an 8 ch rx: You have to make sure you have designated the model properly initially. If you have it set for aiileron differential it won't work. It has to be on flaperons, ailevator and airbrake enabled. Then, it depends on which two channels you have assigned for the ailerons. You need ch 1 for the right and ch 6 for the left aileron, ch 7 for the left flap and ch 8 for the right.

This is the FAQ that explains it:

http://www.futaba-rc.com/faq/faq-9c-q787.html

Also, if you are mixing two elevator servos:

http://www.futaba-rc.com/faq/faq-9c-q29.html

If you can find it still, Harry Higley has a book on programming the 9C that is 30X better than the manual. Tower used to sell it.
Charlie P. is offline  
Reply With Quote
Old 08-10-2010, 09:43 PM
  #3  
vicman
My Feedback: (10)
 
vicman's Avatar
 
Join Date: Dec 2002
Location: Valdese, NC
Posts: 9,910
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: 9C Prgramming: Flaps/Elevator

pm me with your email addy and I can send you a factory manual. It made all the difference for my programing ability.
vicman is offline  
Reply With Quote
Old 08-11-2010, 08:37 AM
  #4  
j.duncker
My Feedback: (2)
 
j.duncker's Avatar
 
Join Date: Jun 2004
Location: Sailing in the Eastern Caribbean
Posts: 4,047
Gallery
My Gallery
Models
My Models
Ratings
My Feedback
Default RE: 9C Prgramming: Flaps/Elevator

I thought he was wanting to set up a mix to give some down elevator with flaps selected.

i have done this several times but as I do not have the tranny to hand just now I don't want to step the OP through it from my memory.
j.duncker is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service