RCU Forums

RCU Forums (http://www.rcuniverse.com/forum/)
-   Questions and Answers (http://www.rcuniverse.com/forum/questions-answers-154/)
-   -   consealing servos (http://www.rcuniverse.com/forum/questions-answers-154/5950463-consealing-servos.html)

cotman 06-05-2007 10:54 PM

consealing servos
 
anyone have suggustions on how I can hide the servos in the wing. Want to make them invisable if possible. Thanks

Don41 06-05-2007 11:11 PM

RE: consealing servos
 
What plane? Are you also looking to hide the linkage?

cotman 06-05-2007 11:17 PM

RE: consealing servos
 
Super Decathlon

scratchonly 06-07-2007 01:09 PM

RE: consealing servos
 
Mount the servos on a 1/32 ply plate with hardwood standoffs to screw the servos to with the servo laying down and tight to the ply. Cut a slot in the ply with the servo arm sticking out. Make the plate to fit between two ribs with 1/4 inch hardwood rails glued to the sideof the ribs 1/32 down (up) from the rib bottom or the sheeting; screw the ply to the rails preferably with #4 counter sunk flat head screws. You can mount the servos with both servo arms facing in or out. Servos with the same rotation will work with a Y harness as ailerons move opposite.

daveopam 06-07-2007 05:43 PM

RE: consealing servos
 
I have done it several times like Scratchonly said. It works very well and is easy to do.

David

mscic-RCU 06-08-2007 03:06 PM

RE: consealing servos
 
i prefer to use 1/16 ply, a little stiffer.


All times are GMT -8. The time now is 03:16 PM.


Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.