DU-BRO Push Rod Seals
#2
My Feedback: (1)
RE: DU-BRO Push Rod Seals
They're in the right order in the picture. The insert goes through the radio box, small end first and glued into place. The boot needs to be trimmed off as for some reason it comes with extra on it. The boot is then slipped over the insert than the O-ring slips over it to hold it in place.
#4
Senior Member
Join Date: Jan 2011
Location: Clive, IA
Posts: 439
Likes: 0
Received 0 Likes
on
0 Posts
RE: DU-BRO Push Rod Seals
Make your own boots out of 1/8" plastic rods and use piano wire for the connection. Just use grease kneaded into1/8" rod to keep water out. Piano wire comes in various diameter. Remember you need only 20 degrees either way for turning.
#5
RE: DU-BRO Push Rod Seals
Grease in the pushrod tube is still the simpilest to do AND last forever. I still have original tubes doing the job with the ORIGINAL grease after 60 years.