2.4 not responding after
#1
Member
Thread Starter
Join Date: Mar 2011
Location: , FL
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
2.4 not responding after
Hey guys so I did what this guy said to set the fail on my car that I just got andnow the breaks stay set and the buggy is not resposting to the rc at all not even for turning. As soon as I turn on he buggy u can hear that the breaks are set.please help ......(Just turn both your transmitter and truck on then find the small black button next to the red LED light on the receiver. Apply full brakes, or your desired failsafe position and hold, then with a small screwdriver or hex wrench push the black button on the receiver and hold until the red light starts to blink {3-5 seconds}. Then release the button THEN the brake and it should be set. Test it by turning your truck and transmitter on applying full throttle {engine not running} then turn your trans. off and the failsafe should activate just like external failsafes.hope this helps )
#2
Member
Thread Starter
Join Date: Mar 2011
Location: , FL
Posts: 41
Likes: 0
Received 0 Likes
on
0 Posts
RE: 2.4 not responding after
damn i was holding the one on the remote control not on the car, thats what i did wrong. i just saw the the car has one, so now how do i bind them togheter