nitro rc truck wont sit still
#1
nitro rc truck wont sit still
i have been searching the web but could not find the answer to my question. Im glad that it starts instantly but the idle speed is extremly high and the cars wheel start to spin faster and faster even when its on the ground. there was a bend in the fuel li e but when i fixed ig it didnt help. any ideas??
#3
Its the caldera 3.0. Redcat. I installed a kill switch on it so maybe there is a air leak between the lines. could this bethe reason? I will deffinatly try to adjust the lsn thanks. Do you think a hobby store would tune it?
#8
ok well i dont think its the lsn. I have it at the proper setting and if i lean it it wont start richen it the car takes like 10 seconds on the pinch test.
An air leak in the fuel line if its not on fully wont allow the engine to start? Thats odd since the engine revs really high and the gap is 1mm. where is it getting aiir from? Also it will only stay on for around 45 seconds.
An air leak in the fuel line if its not on fully wont allow the engine to start? Thats odd since the engine revs really high and the gap is 1mm. where is it getting aiir from? Also it will only stay on for around 45 seconds.
#12
When an engine is broke in an you start the lean tune,the engine will start revving,so there for,it will
require other adjustments to calm the engine down.
If you dont understand how to tune engine,then you might have to find a local hobby shop to do it
for you.
Theres also y-tube vids that will help...