Futaba 3PM + LRP Sphere ESC
#1
Member
Thread Starter
My Feedback: (6)
Join Date: May 2003
Location: Longmont,
CO
Posts: 87
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 3PM + LRP Sphere ESC
Having a problem I hope someone can straighten out.
System is brand new, using LRP Sphere Competition TC ESC and Futaba 3PM TX/RX. When I turn on the power to the system, I have control with the steering servo but nothing from the throttle. If I put the steering servo into the throttle channel, the servo responds so I know the RX is ok.
I cannot get the ESC into setup mode. The SET button isn't broken as I can enter MOD and the SET button lets me make changes there. But when I turn on the ESC, the blue LED stays lit. I hold the SET button down for any length of time and it never enters setup mode so I can set the throttle. The pack is fully charged. The motor is the Vector X11.
Hoping somebody can shed some light.
System is brand new, using LRP Sphere Competition TC ESC and Futaba 3PM TX/RX. When I turn on the power to the system, I have control with the steering servo but nothing from the throttle. If I put the steering servo into the throttle channel, the servo responds so I know the RX is ok.
I cannot get the ESC into setup mode. The SET button isn't broken as I can enter MOD and the SET button lets me make changes there. But when I turn on the ESC, the blue LED stays lit. I hold the SET button down for any length of time and it never enters setup mode so I can set the throttle. The pack is fully charged. The motor is the Vector X11.
Hoping somebody can shed some light.