Hpi .25
I recently bought a hpi .25 of eBay I put it in my car today and when I rolled it over by hand it made a click at tdc and was hard to roll past it almost as if the piston is hitting the head? I started it got it to run for a sec and it cut out just curious before I continue on if there is something wrong
|
The .25 is it pull start type engine or not?
It is normal for a new engine to turn hard due to the tightness of the piston and sleeve use hair dry dryer to heat up the engine to loosen it up during break in, also see your manual regarding break in period. |
The 3 hpi 25s I have all did the same (as was the case with several of my nitro engines. I wouldn't worry about it.
|
ok I checked piston to head I have .020 clearance after I added shims I will take the shims back out and run it. Do you have suggestions on how to break in properly I do not have a manual I bought it off ebay
|
Originally Posted by chazmadaz
(Post 11753302)
ok I checked piston to head I have .020 clearance after I added shims I will take the shims back out and run it. Do you have suggestions on how to break in properly I do not have a manual I bought it off ebay
|
I said I added shims when I thought the piston was hitting so I will take them back out and leave the one original shim that was in there check my piston to head clearance and go from there
|
Do you have suggestions on how to break in properly I do not have a manual I bought it off ebay
Run it reach for @ least a gal or two, lot of smoke. If it's hard to turn use hair dryer to heat up the engine to loosen it up, you might need to keep your glow igniter in to keep the engine running. Others may give you suggestion of how to do it. |
I talked to the previous owner he only replaced the cases I ran it yesterday has a lot of power and runs really good!
|
All times are GMT -8. The time now is 06:38 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.