RCU Forums - g3.0 engine problem.

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Car General Discussions (https://www.rcuniverse.com/forum/rc-car-general-discussions-179/)

- - g3.0 engine problem. (https://www.rcuniverse.com/forum/rc-car-general-discussions-179/7561355-g3-0-engine-problem.html)

firebird1967

05-30-2008 08:39 PM

g3.0 engine problem.

Ok, my engine starts the first pull when it is cold, but when it is hot, it take about 10-15 pulls to start in, can anybody help me?

NitroTherapist

05-30-2008 09:23 PM

RE: g3.0 engine problem.

Is your engine primed enough???

firebird1967

06-03-2008 12:13 PM

RE: g3.0 engine problem.

yes i prime it everytime i start it

firebird1967

06-03-2008 08:49 PM

RE: g3.0 engine problem.

yes after i see fuel in the lines, i give it a few more pulls.

dar123

06-04-2008 12:54 PM

RE: g3.0 engine problem.

is the fuel igniting in the carb?

nitro rc

07-24-2008 09:39 PM

RE: g3.0 engine problem.

its because when the engine is hot, the engine expands meaning less compression. You nead a fairly high compression to start a nitro engine. ALso, when its hot just give it like half throttle while pulling, or let it cool before restarting.

All times are GMT -8. The time now is 07:53 PM.