bashingozzy

Im re-building my sportwerks raven for some winter fun. Iv go tamiya ballons for the receiver and speed controler but what do i need to do for the steering servo? any help would be good

Cheers
Dave

Osirisf16

Put it in a baloon too

bashingozzy

Iv hade ago at doing that but then when i put a hole in the ballon for the spline, the hole just gets bigger and rips lol

Osirisf16

Have a picture of the ballon you're using?

dacaur

put some thick grease on the output shaft, and use hotglue for the case opening and where the wires exit.