biodad25

The problem I have is the old engine has a collet on the shaft to which a keyed spacer fits followed by the flywheel, then a 2 shoe clutch.


Newer engines have no collet on the shaft so I cannot use my current spacer /flywheel.


Has anyone any ideas or have you done this before. I have attached a picture of the current setup.


Any help would be appreciated, I have also attached a picture of my car so far

marwankw

My Feedback: (1)

hi, refer to Inferno MP5 manual, steps 26 to 28 which should give a hint on how to install newer engines.

http://www.retromodelisme.com/scan_p...o-page-20.html

jamesmic

RC10 Stealth Team car.