jeffie8696

OK so Tom wants me to install metal gears in his Clodbuster and he orders integy c22729silver gear set but it takes a mod1 gear instead of the stock 32 pitch pinion, I cant find a mod1 gear to fit the stock motor shafts and dont know what number of gear teeth to get if I did. Any help ? please
Tried the forum search and got nothing

phmaximus

hey are u on facebook?.... check out the clodbusters owners society... but heads up they don't like integy... apparenty they are a bad clone of the Hot racing gears....

jeffie8696

Thanks I will try it, I have no luck with Integy stuff in general.

Next edition

Some have little sleeves for pinions to take it down to a 3.17mm shaft from a 5mm one or you could make one.

jeffie8696

Havent seen one of them yet, I will take a closer look at Great Planes to see if they stock one.

Next edition

Robinson racing reducer sleeve $3 off ebay but you can see how easy it would be just to make one from a steel tube though.

jeffie8696

Thanks I just located it on Great Planes, Now can you tell me what number tooth gear will fit? The gear mesh on a Clodbuster in not adjustable (not by much) so you have to be right on and I don't see a suggested gear from Integy (or any other type of useful information whatsoever for anything they sell).

Next edition

Im not sure,you could measure the diameter end to end of the stock one and get stockists to measure out a mod 1 pinion to that size before you buy it from them.

phmaximus

This might help.... Adjustable motor mount

http://www.ebay.com.au/itm/Hot-Racin...47084b0&_uhb=1

HueyHauler

I don't like Integy either !!!!!!! Tech support sucked. Shipping took forever. Bad times with them not once but a few. They sent me the wrong side Castor Blocks.
The parts that I finally did get have held up. They are well made, I will say.