Buggy owners (zx-5, dark impact, X10, xxx4)
#1
Senior Member
Thread Starter
My Feedback: (34)
Join Date: May 2005
Location: CT
Posts: 7,074
Likes: 0
Received 0 Likes
on
0 Posts
Buggy owners (zx-5, dark impact, X10, xxx4)
Could you guys post up some measurements for the width of these buggies and specify where it was measured? (axle stub to axle stub, wheel to wheel, etc. Thanks
#2
Senior Member
Join Date: Sep 2006
Location: Wichita, KS
Posts: 499
Likes: 0
Received 0 Likes
on
0 Posts
RE: Buggy owners (zx-5, dark impact, X10, xxx4)
248mm wheel to wheel (measured from the bottom of the front wheels while its on a pit stand - its widest point.) This is from my DI.
Hope that helps.
Hope that helps.
#3
Senior Member
Thread Starter
My Feedback: (34)
Join Date: May 2005
Location: CT
Posts: 7,074
Likes: 0
Received 0 Likes
on
0 Posts
RE: Buggy owners (zx-5, dark impact, X10, xxx4)
So a bit under 10". I'm just wondering why the DI looks so much wider than the rising storm when in reality it's less than a centimeter difference. Also, I want to know the popular racing buggies measurements incase I ever wanted to make custom suspension.
#6
RE: Buggy owners (zx-5, dark impact, X10, xxx4)
I wouldn't base a judgment of width on a measurement from wheel to wheel because the wheel nut can be off center, the wheel width can vary, etc...
IMHO, the best measurement of width would be from one attachment pin to the other.
IMHO, the best measurement of width would be from one attachment pin to the other.