breakage
09-02-2007, 02:58 PM
#1
Senior Member
Thread Starter
Join Date: Aug 2007
Location: woodbury,
MN
Posts: 1,290
Likes: 0
Received 0 Likes
on
0 Posts
breakage
dose this happen to your e-maxx? I hit my ramp that is about 1 foot high at full speed on a 1/2 charge and landed slitey on my back wheels and when i gave it gas it did not move. I found out that the front axle snapped and i had a broken bulk head and skid plate. I only had rwd I hit the ramp and the back end fell off.
09-02-2007, 03:20 PM
#5
Senior Member
Thread Starter
Join Date: Aug 2007
Location: woodbury,
MN
Posts: 1,290
Likes: 0
Received 0 Likes
on
0 Posts
RE: breakage
also would these be good bulk heads to buy? http://cgi.ebay.com/T-Maxx-E-Maxx-In...QQcmdZViewItem
09-02-2007, 04:22 PM
#6
Senior Member
My Feedback: (325)
Join Date: Mar 2003
Location: LaGrange, OH
Posts: 14,857
Likes: 0
Received 0 Likes
on
0 Posts
RE: breakage
http://cgi.ebay.com/NEW-Aluminum-Fro...QQcmdZViewItem
these acncm are solid and real strong and cheap.
these acncm are solid and real strong and cheap.
09-02-2007, 05:06 PM
#8
Senior Member
My Feedback: (325)
Join Date: Mar 2003
Location: LaGrange, OH
Posts: 14,857
Likes: 0
Received 0 Likes
on
0 Posts
RE: breakage
I'd get them right from the manufacturer, they a good place .
Rears
https://host446.ipowerweb.com/~acncm...c4325429d9f804
Rears
https://host446.ipowerweb.com/~acncm...c4325429d9f804
09-03-2007, 01:23 PM
#10
Senior Member
My Feedback: (23)
Join Date: Mar 2004
Location: Oshkosh,
WI
Posts: 7,934
Likes: 0
Received 0 Likes
on
0 Posts
RE: breakage
ORIGINAL: novakmaxx
dose any one know of a rely cheap but good rear skid plate.
dose any one know of a rely cheap but good rear skid plate.
09-03-2007, 01:29 PM
#11
Senior Member
Thread Starter
Join Date: Aug 2007
Location: woodbury,
MN
Posts: 1,290
Likes: 0
Received 0 Likes
on
0 Posts
RE: breakage
Is this a good skid plate? http://cgi.ebay.com/INTEGY-REAR-TYPE...QQcmdZViewItem
And I have broken a 3.3 skid.
And I have broken a 3.3 skid.
