HPI TF-20U and RF-20 Binding
#1
Junior Member
Thread Starter
Join Date: Mar 2009
Location: Coral Springs,
FL
Posts: 29
Likes: 0
Received 0 Likes
on
0 Posts
HPI TF-20U and RF-20 Binding
I somehow managed to reset my receiver and have to bind my receiver and transmitter, however i have no idea how to do that because the transmitter doesnt have a bind/setup button.. So if anybody with experience could help would be greatly appreciated.
#2
Senior Member
Join Date: Sep 2007
Location: Cypress, TX
Posts: 1,262
Likes: 0
Received 0 Likes
on
0 Posts
RE: HPI TF-20U and RF-20 Binding
I use a body clip where on the receiver says bind. Place and hold onto the left and right metals that come out, turn on remote holding bind button then on the receiver.
If you can't get it or I didn't make myself clear reply to this and I will help you out.
If you can't get it or I didn't make myself clear reply to this and I will help you out.
#3
Junior Member
Join Date: Oct 2016
Posts: 2
Likes: 0
Received 0 Likes
on
0 Posts
I have a rf-40 2.4 reciever. Ive been for weeks trying to play wit my rc but my throttle no work. Steering works but when i pull trigger it dobt go anywhere. Motor dont even spin. I went from batterystraight to motor touching wires. The motor works
Last edited by Richardhpi; 10-11-2016 at 10:40 PM.