Vorza77

I've recently purchased and built a Mugen Seiki MGT7 eco. I must say the craftsmanship on this vehicle is outstanding. This is my first Mugen and the handling on this vehicle at high speeds is mind blowing. Throughout the build I was contemplating whether I should install a 6s combo and went with a 6s combo decision. I personally will not be racing on tracks but moreover race for recreational purposes and I would like to know the thoughts or even comments of anyone else that are contemplating or have built one these machines.

I do have a question in regards to the default motor mount. Does anyone have any ideas on converting or modifying the mount to accommodate a larger pinion? I'm still researching with the limited information that's currently available on this 1/8th scale but will update the forum with what I've been able to gather.

xoroz

Sorry I do not own an MGT7 but I am studying the possiblity to convert my MBX6 eco to one.
Check it out


mbx6 eco convert to mgt7


front/rear towers
E2537 32 U$ each
E2538 35 U$ each

Short Shocks piston
2x E2539 15 U$ each
Short Shocks Spring
2x E2545 (Silver) Default 5.25T 15 U$ each

Front Bumper
E2414 18 U$

Front Bumper Foam
E2413 11 U$

Body
E1063 37 U$

Diff Oil
B0319 50k 8 U$
B0318 30k 8 U$

Mugen Tension Rod/Body Mount/Front Upper Brace: X7
E2107 13 U$

Mugen Tension Rod/Body Mount/Rear Brace
???????

Stickers
E1059 8 U$

Total: 200 U$

sheograth

Are you using the default motor mount B?