anyone in R/C Three wheeler?
#1
Member
Thread Starter
Join Date: May 2010
Location: karlsruhe, GERMANY
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
anyone in R/C Three wheeler?
I needed a short break after hours and hours of sanding.....so I took my leftovers box , my welding maschine and rest of tubes and built this three wheeler.
#2
My Feedback: (4)
Join Date: Jan 2002
Location: Westhampton Beach,
NY
Posts: 860
Likes: 0
Received 0 Likes
on
0 Posts
RE: anyone in R/C Three wheeler?
nice!! Going for that vintage Morgan look??
http://cycle-car.com/
What parts did you use for the front end and what scale is it?
Thanks,
Bill S.
http://cycle-car.com/
What parts did you use for the front end and what scale is it?
Thanks,
Bill S.
#3
Member
Thread Starter
Join Date: May 2010
Location: karlsruhe, GERMANY
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
RE: anyone in R/C Three wheeler?
Thank you! The driver is 1:3,5 ,my favorite scale.... for the look ? no idea at this time, but i guess it will be a modern design, with a brushless engine behind the driver. the front end is 1/5 scale from FG.
#7
RE: anyone in R/C Three wheeler?
ORIGINAL: fibergless
I needed a short break after hours and hours of sanding.....so I took my leftovers box , my welding maschine and rest of tubes and built this three wheeler.
I needed a short break after hours and hours of sanding.....so I took my leftovers box , my welding maschine and rest of tubes and built this three wheeler.
That's a good looking start fibergless.. are you going after the Can-am trike look?
#9
Member
Thread Starter
Join Date: May 2010
Location: karlsruhe, GERMANY
Posts: 65
Likes: 0
Received 0 Likes
on
0 Posts
RE: anyone in R/C Three wheeler?
Thank you Mudgy! yes the can-am design is a good idea, just the difference that the driver is sitting inside the body in my case