Ground clearance for on-roads
#1
Thread Starter
Join Date: Jun 2008
Location: , GREECE
Posts: 576
Likes: 0
Received 0 Likes
on
0 Posts
Ground clearance for on-roads
Hello guys!What ground clearance should i have with my on road setup?My rc is intented for drifting....I was thinking for 2.2cm...Should i go lower or higher???
#2
Senior Member
Join Date: Feb 2008
Location: Woodland Hills, CA
Posts: 155
Likes: 0
Received 0 Likes
on
0 Posts
RE: Ground clearance for on-roads
Here's a trick i learned, get a large marker and paint the bottom of the chassis. Now set your ride height to about 10mm front and rear. Now run the car for about 5-10 min. then check the chassis (if you have no scrapes lower the car), (if you have some scrapes your close) and (if if have alot of scrapes raise the car).