TIGER76

I ordered a ddm alloy fancover and some other alloy parts ie gas cap,pullstart,engine cover when i got to fitting the fan cover i noticed it wouldnt fit flush to the engine casing as it had 2 raised parts ("nipples" lol cant think of another word to describe it) by the left and right middle screws??

Did anyone else has this problem and did you just grind it down?

I got the gas cap and engine cover fitted but cant fit the rest til ive installed the fancover so may have to grind it down in work today will post some pics when finished

cheers guys

frumpy

There are 2 different ones I think ya got the wrong one maybe[X(]

TIGER76

think your right m8 maybe theres different types[] well grinded and fitted now anyway hehe

frumpy

Hey looks good bud,no sense in sending it back when a little chop chop will do..lol!!

hndaman1

My Feedback: (6)

those parts look good on the clone..

TIGER76

clone?

TURBOFUNGUS

why not sand down the orginal cover?

TIGER76

I was going to do that turbo but the time and finish wouldnt have been half as good and the cover parts were cheap enough
Was looking at an alloy rollcage next but the one ive seen hasnt got the middle down bar for the windows to attach too []