EPP, CF, Coroplast 2M project: COMPLETE!
#1
Thread Starter
EPP, CF, Coroplast 2M project: COMPLETE!
Well,
Here it is!
I test tossed it this late afternoon and in ZERO wind and fading light. Only minor trim changes during the flight - this baby FLOATS!
For a 33 oz foamie I was very pleased! I was tossing from a small "bump" at the end of two soccer fields - maybe about 8 feet above the field and it went accros the one field and 1/4 the way across the other - very nice!
I tossed it back and forth a few times then stood on the "bump" and did 360 degree throw and catches until it was dark! Turns well, doesn't fall out or into the turn, well tempered!
I will set up my bungie launch tomorrow! It seems to handle very well, but given the conditions I was trying to "float it" so I will need to really put it through its paces before I make the final call but so far I am STOKED!
Here is a photo of the finished project:
Here is the beginning of the original thread:
http://www.rcuniverse.com/showthread...546#post556597]
Here it is!
I test tossed it this late afternoon and in ZERO wind and fading light. Only minor trim changes during the flight - this baby FLOATS!
For a 33 oz foamie I was very pleased! I was tossing from a small "bump" at the end of two soccer fields - maybe about 8 feet above the field and it went accros the one field and 1/4 the way across the other - very nice!
I tossed it back and forth a few times then stood on the "bump" and did 360 degree throw and catches until it was dark! Turns well, doesn't fall out or into the turn, well tempered!
I will set up my bungie launch tomorrow! It seems to handle very well, but given the conditions I was trying to "float it" so I will need to really put it through its paces before I make the final call but so far I am STOKED!
Here is a photo of the finished project:
Here is the beginning of the original thread:
http://www.rcuniverse.com/showthread...546#post556597]
#3
Thread Starter