Anyone need foam cores cut?
#1
Thread Starter
My Feedback: (1)
Anyone need foam cores cut?
Just throwing this out to see what interest I develope. I have been flying models for a few decades now, still remember Kraft Radios and Escapement systems too. Back in the early 90's I discovered slope, the Navy stationed my in San Diego, Ca. Torrey pines and many sites on the inland range were all I needed. I am now stationed on the USS Backyard, A.K.A. Civilian, and living in the flatlands of central Texas, we have hills enough, just not on the scale of you west coast folks. The cost of living in Cali is just too nuts for me, besides I am into aero-tow these days...
So like I said modeling has been my thing for sometime now, I have been cutting wing cores for the SPA guys (I can give referals)for a while and just wanted to offer up my services to my favorite group, sailplaners (is that a word?). I offer very reasonable rates, I stand behind my work 100%, I prefer custom work, I will cut any profile you supply or specify an airfoil. I use white styrene and the "Blue Stuff" for those who prefer it (DS guys?) Discounts for larger orders.
I want to keep the building aspect of my beloved sport alive and if possible growing. If you are a builder or just want to tinker with an existing design... Lets melt some foam. My contact e-mail is: [email protected]
Peace, Wolf
So like I said modeling has been my thing for sometime now, I have been cutting wing cores for the SPA guys (I can give referals)for a while and just wanted to offer up my services to my favorite group, sailplaners (is that a word?). I offer very reasonable rates, I stand behind my work 100%, I prefer custom work, I will cut any profile you supply or specify an airfoil. I use white styrene and the "Blue Stuff" for those who prefer it (DS guys?) Discounts for larger orders.
I want to keep the building aspect of my beloved sport alive and if possible growing. If you are a builder or just want to tinker with an existing design... Lets melt some foam. My contact e-mail is: [email protected]
Peace, Wolf
#3
Member
Join Date: Jun 2008
Location: mlbourneVictoria, AUSTRALIA
Posts: 83
Likes: 0
Received 0 Likes
on
0 Posts
RE: Anyone need foam cores cut?
could you do a 4mtr span 2 piece with a eppler E193 with a chord of 8inch chord and to fit airbrakes at 25% from LE and "Barn door" ailerons that will be balsa veneered because obechi is so expensive because of our asion pacific friends' rates