Main Shaft Spacer Question
#1
Member
Thread Starter
Join Date: Oct 2012
Location: Essexville, MI
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
Main Shaft Spacer Question
I am building a Trex550e v2. Is the main shaft spacer required? When the main shaft has the main gear installed there is zero playup and down. I dont even think the spacer would fit.
#2
Senior Member
Join Date: Jan 2008
Location: Tortola , VIRGIN ISLANDS (BRITISH)
Posts: 2,300
Likes: 0
Received 0 Likes
on
0 Posts
RE: Main Shaft Spacer Question
Hey Bro
Just try it. If the bolt does not line up to get the bolt through ...Also itmight pull the gear up in a better position on the pinion. Did you substitute a part?
Best wishes for the New Year and heli flying
Just try it. If the bolt does not line up to get the bolt through ...Also itmight pull the gear up in a better position on the pinion. Did you substitute a part?
Best wishes for the New Year and heli flying
#3
Member
Thread Starter
Join Date: Oct 2012
Location: Essexville, MI
Posts: 36
Likes: 0
Received 0 Likes
on
0 Posts
RE: Main Shaft Spacer Question
I will give it a try. I have not substituted any part. It has 2 spacers. The .3 and a .5. Do you recommend just getting any of those in there? Happy new year to you too! I can't get this heli built fast enough!