flymentor servo setup
 

fellow RC-ers ...just getting back into RC helis after a little hiatus...i am building a HK600 heli and am setting up my servos and trying to install the flymentor 3D (and the flymentor may not really have anything to do with my question). My questions is this - (i had fully set up my heli then trying to install the flymentor) ...after setup of the servos when my left stick (throttle) is at low stick then i am assuming the servo horn cannot be parallel with the ground?...am i missing something here?...if when i installed servos i set up parallel at half stick then low stick must mean parallel is only when heli is at half stick...please advise.

thanks