RC Helicopter General Discussions Discuss RC Helis here. Nitro, gas, turbine and any make, model or brand not having its own specific forum below!

Blade 130s Int/3D Flight Modes - Full Throttle


Old 05-17-2019, 11:02 AM
Junior Member
Thread Starter
Join Date: May 2019
Posts: 2
My Gallery
My Models
My Feedback
Default Blade 130s Int/3D Flight Modes - Full Throttle


I have just recently got into RC Helicopter flying after buying a cheap Gyrocopter...I wanted something with a bit more power so I bought a Blade 130s. (I know this isn't a beginner helicopter, but I am taking small steps for now)

I have set it up correctly as it was an RTF version and done what the manual suggested

The problem I am having (and I was lucky to be holding the helicopter at the time), - when I switch from normal mode into intermediate or 3D - it just went full power and lift even though the throttle was at zero.

When switching back down to normal the rotor/blades powered down, I then tested the throttle on normal, and it works as expected.

What could be causing the helicopter to full throttle in them modes when the throttle is at zero? Have the rates switched

I have just ordered a DX6e Transmitter but it won't be delivered until Monday so I'm reluctant to try adjusting values on the basic RTF transmitter that I got with the 130s.

If you need any more details I will be happy to provide.

Thank you
toXicRC is offline  
Reply With Quote
Old 05-20-2019, 05:29 PM
Rockin Heli
Join Date: Jul 2012
Location: Saint Gabriel, LA
Posts: 127
My Gallery
My Models
My Feedback

Can you check on your radio screen to see if the Throttle is set at 0 when you have it on the high rate?
Rockin Heli is offline  
Reply With Quote

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Thread Tools
Search this Thread

Contact Us Archive Advertising Cookie Policy Privacy Statement Terms of Service