Go Back  RCU Forums > RC Helicopters > RC Helicopter General Discussions
Reload this Page >

Blade cp Brushless tail motor

Notices
RC Helicopter General Discussions Discuss RC Helis here. Nitro, gas, turbine and any make, model or brand not having its own specific forum below!

Blade cp Brushless tail motor

Old 06-22-2007, 05:28 PM
  #1  
cbrian4
Senior Member
Thread Starter
 
Join Date: Jun 2007
Location: gilbert, AZ
Posts: 156
Likes: 0
Received 0 Likes on 0 Posts
Default Blade cp Brushless tail motor

Ok, i know that this has been brought up about a million times, but how EXACTLY do i upgrade to a brushless tail motor, can i keep my 4-in-1? can i keep my stock main motor and upgrade to brushless tail? i need help PLEASE.
Old 06-22-2007, 07:14 PM
  #2  
mrasmm
Senior Member
 
Join Date: Jan 2007
Location: Sometown, Northern Utah
Posts: 4,432
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Blade cp Brushless tail motor

yes you can, you would just need the DD brushless motor, a brushless esc and a servo lead, as well as the lengths or cord to hook the motor up to the esc.

basically you splice the power lead to the esc into the jst lead that goes to the 4 in 1. After that you solder on the servo lead to the 4 in 1 and run that to the ESC making sure to solder the outside two wires, and not the inside two. The instructions are here http://www.heli-max.net/mediawiki/in...ushless_Part_2 but make sure you do the tail motor and not the main.

Then you just run the wires for your tail motor from the ESC and that should about do it.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.